PDA

View Full Version : Leovince Help!!



speeddemon2k3
01-19-2003, 06:47 PM
When you first buy a leovince ZX pipe it comes with a white cone inside i removed that cos the dealer told me to but there is another circular piece of metal that the cone was inside do you remove this aswell? If so how do you do it.

P.S Can some1 tell me how 2 post a pic show i can show u wat im talkin bout

PABBY
01-20-2003, 12:14 PM
You need to have the pic hosted on a site, use the image button on the left of the posting screen and put in the link.:)

micah apriliaforum com
01-20-2003, 12:48 PM
You use a die grinder or dremel to cut the spot welds and then use a spring puller to grab the cone and pull it out of the pipe. On all the Leos I have seen that is all that is required to derestrict.

jonnyhonda
01-20-2003, 01:24 PM
errr, there are 3 restrictions in total. The cone, A slight washer type restriction, And a Wire mesh plate at the end of the cone when it starts to close.
You have to cut the ZX open to do this. So if you want to you can. Go to the LeoV website. It will show you the the part where the restriction is.

speeddemon2k3
01-20-2003, 05:39 PM
<img src="http://www.leovince.com/scoot/img/zx-spacc.jpg" style="border:0;"/>
Thats it the circular bit of metal that doesent sit flush with the part of the exhaust that bolts onto the bike. Should this b removed?

ip
01-22-2003, 10:23 AM
the wire mesh on walls are for noise reduction --its not restriction --