PDA

View Full Version : 10 RSV4 Service Light



BDFST507
04-06-2019, 11:49 AM
hello,

looking for any additional advice. I laid the bike down last fall at a track day and have had a service light/SERVICE message ever since. Have not been riding it FYI. Getting everything buttoned up for this season and cannot figure this out. Initially had a service light with DSB 07 MEMO would light up eveytime I tried anything. Checked oil pressure sensor/replaced. Reset dashboard and coupon. Light stays off till I actually move about a block, turn around, reset and try again. Same thing each time. I searched and went ahead and dropped the oil pan and checked the relief valve, cleaned up and put everythin back together. Same thing, error stays off till attempt to actually move.

Now I get a servce light and SERVICE message, but no DSB codes?

Thank in advance

plocky
04-06-2019, 05:12 PM
You need to read the ECU fault codes to see what it is.
DIY >>https://www.apriliaforum.com/forums/showthread.php?282399-Guzzidiag-for-RSV4

Or take to a Piaggio/Aprilia dealer & have them read it with PADS

BDFST507
04-07-2019, 11:45 AM
You need to read the ECU fault codes to see what it is.
DIY >>https://www.apriliaforum.com/forums/showthread.php?282399-Guzzidiag-for-RSV4

Or take to a Piaggio/Aprilia dealer & have them read it with PADS

Was hoping that wasn't the case:( lol I did just order the cables for guzzidiag though.

Thanks!!

BDFST507
04-13-2019, 11:34 AM
You need to read the ECU fault codes to see what it is.
DIY >>https://www.apriliaforum.com/forums/showthread.php?282399-Guzzidiag-for-RSV4

Or take to a Piaggio/Aprilia dealer & have them read it with PADS



Any issues with the guzzidiag website? my pc isnt able to access the site?

plocky
04-13-2019, 07:15 PM
Any issues with the guzzidiag website? my pc isnt able to access the site?
For some reason the site was down yesterday, it's back up again now.

https://www.von-der-salierburg.de/download/GuzziDiag/