View Full Version : Help, advice needed exhaust for 2016 engine

03-05-2019, 06:43 AM
Hello, i need a little help/advice

I have installed the 2016 engine to my 2013 bike,
but i want to keep the akra slip-on (akra is expensive) from my 2013 exhaust, and i bumped into this (see image).
Is there a some kind of link pipe from colectors 60mm->56mm slipon, or do i have to weld it for it to work, or other de-cat pipe is needed ??


The image shows not connecting de-cat pipe 56mm for 2013 akra slip-on, to a 2016 collector 60mm

Should i buy this pipe ?

says here its a 60->60 de-cat pipe, that should fit the 2013 akra slip-on ?

03-05-2019, 06:37 PM
My understanding is that you will lose power keeping the smaller diameter system.

03-06-2019, 05:11 AM
That's correct, that is why i want to buy the correct dec-at 60mm pipe, and asking if the one i mentioned in the link will fit,
as to my knowledge the entrance on the akra slip-on is 60mm diameter but want to make sure as not to make unnecessary purchease.

Gabro will know for sure as he did similar engine swap.

03-12-2019, 09:06 AM
The arrow link pipe will work as it mates to the 16 header and to the 60mm acra can.

03-12-2019, 09:12 AM
Ok, thanks.