PDA

View Full Version : Arrow exhaust installation question



absinth
05-12-2014, 05:04 PM
Hi all

I'm installing my exhaust tomorrow or the day after and just wanted to know do you need to remove the tank in order to disconnect the lambda (O2) sensor in the exhaust. Or is there a trick to doing this with the tank on. I don't mind removing the tank but if it can be avoided it's a lot less work.

ps: is there anything else I should watch for or any other tricks or pointers it would be greatly appreciated

xactoman
05-13-2014, 08:09 AM
the o2 sensor runs right up under the tank and plugs in by the ECU. You can't get to the connector unless you take off the tank. Honestly, it's pretty easy to do compared to some sport bikes.