PDA

View Full Version : Need HELP , new Rick's stator from AF1, new R/R



helium
08-12-2011, 06:24 PM
Hello all - I replaced my stator with a Ricks unit from AF1 , also replaced my regulator/rectifier with a Cycle Electric unit. The new R/R doesn't have the mysterious black wire that the stock R/R had ( which is a 12volt hot lead going into the stock R/R ). My question is --what should I run this wire to ? I ran the bike at idle only with the black wire un-connected and after a few seconds the "EFI" and " red triange" lights appear. The bike sounds great and 13.8 volts at the battery, 25 volts ac at all of the 3 phase leads (at idle ). Any help will be greatly appreciated. Thanks in advance..

Micah / AF1 Racing
08-13-2011, 07:41 AM
You need to pop into your closest dealer for an Axone or Navi scan to find out what error is bing recorded by the ecu. If it recorded he red triangle of death the ecu has a story to tell on the next data dump!