PDA

View Full Version : Alarming problems!



CCEMN1
04-05-2004, 09:06 AM
I recently installed a Scorpio SR-i500 alarm on my 2004 RSV-R Mille. It's a real sweet system, but I can't get the bike to start since the install! There's NO ignition cut-out feature in the alarm system, in fact it's a very simple 5 wire hook up. Hot, ground, tail light, and each rear turn signal. I've got good batery and I don't think it's a cut out switch, because I can hear the fuel pump run, while depressing the start button! I've only got 900 miles on this bike and love it! I want to go riding!!! Can anyone PLEASE help me??? Thanks, CC

orpheos
04-05-2004, 11:03 AM
Did you connect both of the grounds? One to the battery and the other to a black wire?

Also, did you connect the turn signal connectors to the blue wires?

Disconnect all the plugs from the snap connectors and try to start your bike, if that doesn't work leave it disconnected and check your fuses.

DockingPilot
04-05-2004, 12:39 PM
Look on another thread here. There is referance to alarm installs with this bike. I remember reading about aprilia sending out a bulliten on it. Ill be in LBI this summer with my RSV, I give you a shout.