View Full Version : Clutch lever engagement

04-02-2004, 01:20 PM
OK so I bled the master cylinder and can get the bike into neutral much easier now but the clutch lever takes more effort to pull.
That isn't really a problem but I was curious as to where the clutch should engage. It is engaging now when I have the lever pulled almost all the way in. Before I bled it the lever was enagaing almost right away when I pulled in the lever.

I am going to fool with the adjustments.
Just curious as to anyones preferences as far as settings go??


04-09-2004, 09:42 PM
I found my clutch to be excessively difficult to operate, especially in the city. After about an hour of riding around, I wasn't very enthusiastic about riding any more. I have the billet slave and have replaced it and noticed a huge difference. My clutch disengages about 5mm after pulling it in. I don't know if this helps, but good luck!