Burnt cables tuono 2003

[john in sweden]

Hi ! I just discovered some really bad cables at right rear side of my bike,
It seams out like the former owner have played with some stuff,
Does anyone recognise these burnt cables ?
It it for the tilt sensor ?
If it is it explains why I can't find it at my bike,

I understand I have to order a new harnes and fix it soon as possible,
But first I would like to know what they are for .

Best regards from Sweden

Link to my problem:
https://www.dropbox.com/s/rfjb3bc5st...55.32.jpg?dl=0

[redratbike]

Be more people looking in the tuono section repost there

I don't recognise the colour code of the wires to assist

But you should have 3 relays in a row and the tilt switch is one of those

[haga lout]

Looks like a 12v supply from battary for a trickle charger where does the other end of the wires go? Is there a 12v supply there ( switched on or switched off) if your after a wireing loom I have one that came with a lot of bits off a tuono raceing it's not been chopped into and has been boxed up make me a offer as I sold the tuono 4 years ago

[john in sweden]

yes maybe im intrested of your harness,,
i will controll the harness more first at my bike,,
there is som harnes at ebay so if you are intrested of prices like that it is ok for me.

best regards from sweden.

Looks like a 12v supply from battary for a trickle charger where does the other end of the wires go? Is there a 12v supply there ( switched on or switched off) if your after a wireing loom I have one that came with a lot of bits off a tuono raceing it's not been chopped into and has been boxed up make me a offer as I sold the tuono 4 years ago

[Stu_O]

Hi ! I just discovered some really bad cables at right rear side of my bike,
It seams out like the former owner have played with some stuff,
Does anyone recognise these burnt cables ?
It it for the tilt sensor ?
If it is it explains why I can't find it at my bike,

I understand I have to order a new harnes and fix it soon as possible,
But first I would like to know what they are for .

Best regards from Sweden

Link to my problem:
https://www.dropbox.com/s/rfjb3bc5st...55.32.jpg?dl=0

Those are the positive and earth wires in the harness that should be connected to the voltage regulator's earth and DC+ connections. High resistance has caused enough heat to melt the insulation and ruin the wires. All of that damage has to be cut out and replaced. I also see a cut in the insulation of one of the AC yellow wires. This is what happens when a butcher tries to remove the charging system brown and white connectors.

[redratbike]

Time to buy something like this and swap part of the loom out

https://m.ebay.co.uk/itm/APRILIA-RSV...%257Ciid%253A3