How do I apply this Anaerobic Gasket Maker? Fuel pump.

[jmccalip]

Does it go directly on the oring or what? I'm confused here. Can't afford to mess up since it's $5 per 6ml.

[wickedmanwicked]

Not sure what you are talking about however if you have a new "O" ring you shouldn't need any other type of sealant. Just a very thin film of rubber grease (or vaseline) if anything.

[jmccalip]

Not sure what you are talking about however if you have a new "O" ring you shouldn't need any other type of sealant. Just a very thin film of rubber grease (or vaseline) if anything.

I'm using it to reseal a warped tank that I just leveled flat again. I'm ready to assemble, I just need to know how to apply this stuff. I've read of people applying it to the actual oring on here, but that doesn't make sense.

[anzacinexile]

You need a thin film on both mating faces and allow it to go tacky before assembly. Wont do any harm if it gets on the O ring BTW