Results 1 to 8 of 8

Thread: Rear wheel drag...

  1. #1
    apriliaforum expert olie's Avatar
    Join Date
    Jan 2004
    Location
    Hill Country, Texas
    Posts
    3,083

    Rear wheel drag...

    ...when the bike is hot after an average trip, the rear wheel drags ...meanwhile the brake disc is not that hot.

    loose front sproket? chain is not new but it is not that bad either!!!

    Ideas before I take it to Micah?
    09 Red Connie, Kawa C14 ABS (GTR 1400), 48k+ miles

    03 Cappy; 07 Tuonita, both gone but never forgotten

    Touring Pics:
    https://skydrive.live.com/?sc=photos...AE9C&sc=photos
    https://skydrive.live.com/?sc=photos

  2. #2
    apriliaforum Junkie weasel221's Avatar
    Join Date
    Mar 2012
    Location
    in my house, on my street in Ohio
    Posts
    375
    have you 'adjusted' the brake lever height/travel like i did?? lol
    rulz, we donn neeeed no steeenkin rulz....


    inside rulz!!

  3. #3
    apriliaforum expert GreaseSnake's Avatar
    Join Date
    Dec 2008
    Location
    Sweden, you know home of the blondes
    Posts
    943
    Check the hub and wheel bearings.
    When exiting the corner I suddenly ran out of talent and fell off the bike.
    2008 Tuono Factory R - 141whp, 131Nm! Eleventwentyseven No.1
    2007 Tuono 1000 R - 129whp, 97Nm The wife's ride.

  4. #4
    apriliaforum expert ffkevinking's Avatar
    Join Date
    Aug 2004
    Location
    AKRON OHIO!
    Posts
    1,282
    alignment

    kev
    08 KWS Tuono Factory
    TTX shock
    Leo Factory "big" full TI exhaust
    Yoyodyne slipper clutch
    Rizoma bar ends
    Full tune from KWS

  5. #5
    apriliaforum expert olie's Avatar
    Join Date
    Jan 2004
    Location
    Hill Country, Texas
    Posts
    3,083
    Checked the alignment ... probably i did overtight the rear axle nut. I will be testing the bike tomorrow, I rode my Kawa today aka Miss Reliable!!
    09 Red Connie, Kawa C14 ABS (GTR 1400), 48k+ miles

    03 Cappy; 07 Tuonita, both gone but never forgotten

    Touring Pics:
    https://skydrive.live.com/?sc=photos...AE9C&sc=photos
    https://skydrive.live.com/?sc=photos

  6. #6
    apriliaforum expert olie's Avatar
    Join Date
    Jan 2004
    Location
    Hill Country, Texas
    Posts
    3,083
    Slighly better after a couple readjustments but still ...not good enough. Nice to have 2 bikes...
    09 Red Connie, Kawa C14 ABS (GTR 1400), 48k+ miles

    03 Cappy; 07 Tuonita, both gone but never forgotten

    Touring Pics:
    https://skydrive.live.com/?sc=photos...AE9C&sc=photos
    https://skydrive.live.com/?sc=photos

  7. #7
    apriliaforum prov-nov
    Join Date
    Jan 2007
    Location
    Coventry, England
    Posts
    70
    Remove the rear caliper (two bolts) and keep it clear of the wheel. If the drag has gone you need to service the caliper, if not you've crushed the spacer between the wheel bearings by overtightening the wheel spindle. Cheap to buy, a pain in the arse to replace.

  8. #8
    apriliaforum expert olie's Avatar
    Join Date
    Jan 2004
    Location
    Hill Country, Texas
    Posts
    3,083
    GOOD NEWS !!!

    I disassembled the Caliper, did some cleaning, move the pads back and forward as one seemed not to be moving freelly and.... voila, working perrrfect, tested the bike during 3 rides without any issue.

    thanks for all suggestions!!!
    09 Red Connie, Kawa C14 ABS (GTR 1400), 48k+ miles

    03 Cappy; 07 Tuonita, both gone but never forgotten

    Touring Pics:
    https://skydrive.live.com/?sc=photos...AE9C&sc=photos
    https://skydrive.live.com/?sc=photos

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •