Aprilia RS50 - Red Lion Edition

[ryanperkins]

cheers but i know, but atleast its all intact and not bent like my old one :P im gunna have a respray sometime in the summer thinking a nice purple but i dunno yet. just gunna get some touch up paint for now haha

[Michelet]

Hehe, everything is better than purple

[Michelet]

Do anyone want an update?

[nicketynoo]

yeah come on update!

[Michelet]

Hehe, okay then!

Soon I will have an exhaust hanger in my mail box. Thanks to nicketynoo! Swapped it for an intake manifold.

Just did another swap: I got, Hebo Titan, Original Cylinder (Mint condition) + 500 Norwegian kroner (NOK) and the one I swapped with got a Yasuni R3 and a seized TP75!

Will soon get a kick axle in the mail with 325 NOK and then I will send this person a Dellorto 21mm

LOVE Swapping parts!

[Michelet]

Sorry for not giving you guys updates, but I have a thread here: http://apriliaforum.no/viewtopic.php...t=7367#p176640

I could need some help with my "shopping kart".
What should I buy and what shouldn't I buy?

0,40mm Reeds
http://www.easyparts.nl/showarticles...40_Val.Or.html

15 tooth front sprocket
http://www.easyparts.nl/showarticles..._Afam_AM6.html

47 tooth rear sprocket
http://www.easyparts.nl/showarticles...-2005_47T.html

BR10ES NGK Sparkplug
http://www.easyparts.nl/showarticles...GK_Br10es.html

[chrism15]

what is the rest of your set up?

0.35mm reed petals might be a bit more responsive

[Michelet]

Setup - June 30, 2012

TP75 (Pink)
Dellorto PHBL24
Hebo Titan
Stock Airbox

[Rexagon]

Redo the helmet? Make it match, would like a hell of a lot sicker if you did!

[chrism15]

id go for 0.35mm reeds as id expect them to be more responsive

[Michelet]

Patrick recommended 0.40mm reeds for my setup I think..
However 0.30, 0.35 and 0.40 is included in the kit!

[chrism15]

Patrick recommended 0.40mm reeds for my setup I think..
However 0.30, 0.35 and 0.40 is included in the kit!

if patrick advises 0.40 use 0.40 he has ALOT more experience with your kind of set up

however if you get them included you can always try 0.35mm and if it runs a little ru=ough then upgrade 0.40mm

[Michelet]

Hehe, I'm used to running with the stock reed so think I'll feel a biiiig difference anyway!

Does anyone know if those reeds are good, or should I go for something else?

[chrism15]

stock reeds normally dont last very long with a set up like that, and run like a bag of shit anyway

if the reeds are too thin they wont close in time to keep the compression but because they are thinner you get better throttle response because they can open quicker and easier

when they are too thin they can permanently bend open slightly due to the excessive wear from a bbk

if they are way to thin then there is a chance they can rip off with the increase of pressure on them and wizz round the crankcase ruining crank bearings ect

[camb00]

0,35 would be better 40 is quite big,
Chrism you are wrong

If they are too thin at high rpms they will start to hover and the bike will run shit

Get the malossi reed pack