small cap fell off the turn signal switch

[george mitchell]

after coming out from shopping i noticed the little cap on the flasher signal was missing . luckily i looked on the ground and found it . when i got home i thought about gluing it back on but decided not to . i figured i might not be ble to remove it should it need to come off . so i got a small piece of that gummy putty you use to stick posters on walls .i made a small ball of it ,it's kinda like silly putty ,then stuck it to the inside ot the cap that covers the post for the blinkers .then i pushed the small cap onto the post . now it will stay put and if ever need to take it off no problem .works for me .

[tomd]

yes george don't glue eet

[JulioB]

AF1 also sells new ones.

[Matthew Mimmack]

Do they sell one for the s 500 04. Wane I ask they told me no, an tried to sell me the hole unit. For $150 And all I need is the switch cap this was a couple of years ago. They said the one they have on the site is not for the scarabeo 500

[JulioB]

Sorry, according to the description it covers everything but the S500
http://www.af1racing.com/store/Scrip...idproduct=4172

[george mitchell]

nope no glue ...

[Bob Walker]

You can use a drop of silicon rubber to hold the button without making a permanent attachment.

[Jerold]

When mine fell off in the 3rd month of ownership in Oct 2007, they replaced the entire assembly, which reset my milage to zero????
I told them it would be OK to just get me a new cap, but they insisted????
It obviously cost me nothing.

after coming out from shopping i noticed the little cap on the flasher signal was missing . luckily i looked on the ground and found it . when i got home i thought about gluing it back on but decided not to . i figured i might not be ble to remove it should it need to come off . so i got a small piece of that gummy putty you use to stick posters on walls .i made a small ball of it ,it's kinda like silly putty ,then stuck it to the inside ot the cap that covers the post for the blinkers .then i pushed the small cap onto the post . now it will stay put and if ever need to take it off no problem .works for me .

[tomd]

i think the one from my 150 will swap i'll try in a few i use goop to apply and twill pull off if needed but will never fall off ever

[george mitchell]

see i'm not the only one ..lol..

[tomd]

I actually knocked the button off the 150 was driving n noticed it went bck where I waws parked there twas on gnd

[george mitchell]

we both found ours ,hard to believe . guess we were lucky .

[Snow Dog]

I lost mine about a month ago in a parking lot. I found it, as well. You'd think the thing was glowing with our success rate.

I did end up gluing mine on, but I guess that may have been a mistake. Oh well, live and learn and what not.

[george mitchell]

yeah i made a mistake once but i can't remember what it was .lol ! ! if you've never screwed up anything, you haven't done much !!