I have a 2010 SR50 R Factory that I'm derestricting and have a little brain fade going on. I took it apart over a week ago and have it almost all the way back together, but thought I lost a trans cover bolt. I was looking at the parts diagram and see 1 of the holes in the trans cover does not have a bolt, is this correct?
Please see attached PDF file.
Thanks,
Chris
Last edited by cboehme; 05-25-2011 at 11:42 AM. Reason: bad attachment
My scoot is a 2009. I have the side cover off right now and have a bolt for every hole. However when it get put back on, I will leave the very front lower one out. Its a pain in the butt to get at with the lower fasia on.
Then maybe someday when I get the CVT tuned just right. I will stick it back in there.
I could not get your file to open.
Keith
( Temperance, MI ) Good to see another East sider on here!
---------------------------------------------------
2009 SR 50 FACTORY WHITENGK laser platinum ZMR7AP spark plug
2.8.0 ECU MAP DE-RESTRICTED ( RING & PLATE )
LEO VINCE ZX-R PIPE
MALOSSI 70cc BIG BLOCK KIT, Gasket matched.
20mm intake and TB. ( Bored out )
Malossi 5.5 rollers ( 5.1/5.7 mix )
Red springs
HGT Gen 2 black fuel regulator set at 130 PSI
Malossi VL13 reeds
New top speed of 60 MPH flat ground.
This is just a shot in the dark but I have left bolts in the clips that hold the rear brake line to the case and forgotten that they were still in there.
2009 SR FACTORY
Derestricted
Water trap
Leo ZXR with supplied springs and rollers
3 degree key
Malossi MHR reeds w/o stuffer
Questionable cylinder
LOL!!!!!! Your not alone.
To funny.
Keith
---------------------------------------------------
2009 SR 50 FACTORY WHITENGK laser platinum ZMR7AP spark plug
2.8.0 ECU MAP DE-RESTRICTED ( RING & PLATE )
LEO VINCE ZX-R PIPE
MALOSSI 70cc BIG BLOCK KIT, Gasket matched.
20mm intake and TB. ( Bored out )
Malossi 5.5 rollers ( 5.1/5.7 mix )
Red springs
HGT Gen 2 black fuel regulator set at 130 PSI
Malossi VL13 reeds
New top speed of 60 MPH flat ground.
Thanks Shiver, see if it will open now? I just bought this thing 3 weeks ago and came across HGT's website, and the fun began. Rich set me up with a GP pipe and derestricted my ECU. I bagged and labeled all the other screws when taking it apart except for those for the trans cover.
I found this thing used with 12 miles on it and thought this would be a fun toy to play around on. My friends laugh at me because I already have 2 Harley touring bike as well.
Posting Permissions
Reply With Quote