Capo 2006,map 429.20011,before IFT 0-LTFT 4,2-CO 1,6===now IFT 3,1-LTFT 4,2-CO 3,1.And one interesting thing,before I had rough gear changing,but after CO setting,shifting is smooth![]()
Excellent!
Be careful & smooth with your throttle use in 1st gear (& 2nd gear with a 16t cs sprocket or a passenger) while you learned its new throttle characteristics. Not everyone enjoys or appreciated BIG wheelies, and they are MUCH easier to do on your Capo now!
Good luck!
Catfish ...
![]()
sold: "01 Caponord |Flame Red|, Modlist done: Honda CBR600 RR Mosfet (FH008) Rectifier Mod, Brown Connector Mod
now: "04 Caponord |Rally Raid| FH016 Mosfet R/R | GPR Titanium Exhaust|
01 Futura [infinity blue]
Caponord Stanleybobly style loomed MOSFET Rectifiers & Fuelline Kit FS
Just installed Catfish 429 2011 map (previous was Catfish 429 for 12 months), initial impressions are that it's much smoother at low revs, but seems a little muted higher up. There may be a couple of reasons for this, 1st being that before riding it I was playing with my Dorsoduro, 2nd being I only took it for a short run. I will be commuting on it all weekend so should be able to get a better feel for things. Thanks for the opportunity to try your maps Catfish.
08 ETV 1000 Caponord
Multistrada 1200
Having used the bike all weekend with the 2011 map installed, I have to admit its the best map yet. Where I work there is a 20MPH speed limit and normally I would be swapping between 1st and 2nd continuously, now I can potter around in 3rd gear. Out on the open road the bike runs great, i can now run down to 40MPH and accelerate without too much lumpiness, as someone else commented, could now use a 7th gear.Really smooth and very useable. Thanks again.
08 ETV 1000 Caponord
Multistrada 1200
Catfish... pardon me for asking stupid question here (I've asked a few the last few days I'm sure)... I have a 2004 bike. With Lamder (02) sensor and on the stock pipes little bulges inside the link pipes on both sides so I assume Cats? I am however looking to fit a set of non cat (non bulges link pipes) with Remus Revolution cans... Question now is what map should I use... 050429 2001 version or another? Just not sure if the remus will kick things out at all.
Thanks