View Full Version : Cut down powervalve
10-06-2004, 07:09 AM
Is there any advantage of fitting a blanking plate with a cut down valve instead of working powervalve or is it just people derestricting bikes cheap?
10-06-2004, 09:35 AM
surley it would lagg in the midd range, where its designed to have a fully closed port...
ask johnny, he's done it.. im sceptical myself...
10-06-2004, 09:51 AM
I also did it, basically you will gain no more power at all, you will lose all your bottom and mid range power but when you hit 8k revs it takes off like a twat! My advice would be to leave the pv the way it is, with a blanking plate it is much harder to use in town riding and what not, plus you have to slip the clutch a lot more than normal!
10-06-2004, 09:57 AM
Jonny only did it because his blade broke, i will say though it does nothing till 8 then goes like hell, but i mean it does nothing before 8.
10-06-2004, 10:25 AM
ive got a blanking plate on mine at the mo, and when it hits 8k, it scares the shite outta me, just have to hold onto the bike, its crazy. luv it
10-06-2004, 03:21 PM
Would be fun in the wet. :D
10-06-2004, 03:25 PM
i wouldnt say goes like crazy, afterall its only a 30ish bhp bike, if your riding properly it should be at them rpm's all the time and not drop down below and out the power really.
useful if its a racebike because its less weight to carry.
10-07-2004, 06:19 AM
to try it unplug the power to the solenoid and then using a cable tie hold the solenoid in with the cable tie so the PV blade is open all the time.
Pulling off is very hard and forget doing hill starts bike is very groogy till you hit 8000rpm and the front wheel will feel like it gonna lift up:D
If your pv is working dont bother.
Powered by vBulletin® Version 4.2.3 Copyright © 2016 vBulletin Solutions, Inc. All rights reserved.