clutch

[fishy1]

After a run out my engine sounds right nasty at tickover, if I pull the clutch in then the noise disappears and it sounds fine. The bike has done only 8500km and I will be changing the piston rings next weekend(going to snet to watch racing this weekend so need bike, long way!) are there any adjusters on the clutch or anything else I should check while the bikes in bits? Thanks

[jet ski Mik]

adjust the clutch up , it just sounds like theres a little to much play in there, or ya burnt it out by slipping the clutch to much ... its either one of em , i am going for first.

[fishy1]

how do I adjust the clutch(I'm not on about at the lever)?
I've been told there is some sort of worm adjuster, is this right and how do I set it up?

[jet ski Mik]

in ya tool kit under the seat there is a hex shaped spaner this is whaty ya use to do it , ya ahnd book will tell ya how, once tightened up here the noise usually disappears.