rear stands

[tabor410]

where can you find a rear stand for the derbi gpr50r 03 same as 97-03 just diffent body work. or can you make a normal rear stand work?

[RS_Patrick]

What do you mean with Rear Stand? one of those Pit Stands that you put under the rear for to lift the rear wheel of the ground?

Like this:
http://www.easyparts.nl/showarticles_info/0118549826/0-4016-3-1542/Steun_Achter.html

Any bike shop should be able to order one of those for you, try to make sure that it can be adjusted narrow enough for your bike.
There are also versions that you can switch the suports on to a difrent type that fits into the bottom of the front fork so you can change the front wheel, but if your a bit hansy you can make the suports your self, or you can just make the whole thing your self if your handy with a welder.

[tabor410]

yes that what i was talking about thanks for the link just had a hard time finding one that will fit over in canada. thanks

[RS_Patrick]

yes that what i was talking about thanks for the link just had a hard time finding one that will fit over in canada. thanks

But like i said, any bikeshop can order those for you mate, even some autoparts/tool shops can order them easly, so shouldnt be any problem to get one.

P.S. this is the Project section... should have asked in the Off topic section of the RS50 forum.