track day body for 00 Mille

[contender]

:) ....I would like to put my 00 Mille on the track at least part of the time...Has anybody used aftermarket skins,??...if so what kind...positives negatives?...Hot Bodies versus others....

Thanks up front!

[jkflatt]

Hotbodies are not making them for the mille. The only ones I've found making them so far is sharkskins and sebimoto.

I bought the sebimoto from www.yoyodyneti.com. Call Fred at the tech line and he'll make you a deal on the full set.

I've had both sharkskins and sebimoto, and the sharkskins are better in quality, fit and flexability. However for the price savings (about $300 less), the sebimoto are just fine. You will do some spot glazing and sanding, but I have not been disappointed with them so far.

I got the WSB full upper which requires ram air tubes. It's a little more trouble to switch back and forth from street to track than the two piece upper that uses the stock air ducts. However if you drop it, the stock air ducts are not cheap either.

Good Luck........

[kaoyagi]

I dropped mine on track and cracked the ram air tubes. They are expensive for what they are. I think when I looked it was $300.00 for the inner and outer. For now duct tape works, looks like crap but works.

[Chuck B]

Find someone with a plastic welder. The Aprilia plastic requires more heat then usual to weld and you're better off using a scrap piece of Aprilia plastic as the welding rod. Ebay or local salvage yard is a great place for scrap plastic. I had to do my inlet tubes as well.